MULTIFILL 2-5 is a cement-based, colored tile grout. It offers high mechanical strength and color stability. Suitable for joint width 2-5 mm.It is classified as type CG2 WA tile grout according to EN 13888.Fields of applicationMULTIFILL 2-5 is used for pointing tile joints on walls or floors, for indoor and outdoor applications.Technical dataForm: cementitious powderColors: 24Water demand: 6,50 l/25 kg bagBulk density of dry mortar: 1,25 0,40 kg/lBulk density of fresh mortar: 1,60 0,50 kg/lApplication temperature: from +5°C to +35°CAbrasion resistance: ≤ 1000 mm3(ΕΝ 12808-2)Compressive strength after:• 28 days: 40,00 N/mm2• 25 freeze-thaw cycles: 40,00 N/mm2(ΕΝ 12808-3)Flexural strength after:• 28 days: 6,00 N/mm2• 25 freeze-thaw cycles: 5,00 N/mm2(ΕΝ 12808-3)Drying shrinkage: ≤ 2mm/m(ΕΝ 12808-4)Water absorption after:• 30 min: ≤ 2 g• 240 min: ≤ 5 g(ΕΝ 12808-5)Pot life: at least 4 h at +20°CWalkability: after 10 h at +20°CDirections for use1. SubstrateThe substrate covered with tiles should be perfectly clean. The joints should be carefullycleaned and dampened with a wet sponge.2. ApplicationMULTIFILL 2-5 is added to water under continuous stirring, until a uniform paste isformed. A low revolution mixer is recommended for the mixing. The mixture should be left about 3 minutes tosettle and then slightly stirred again. Spread the grout on to the joints, using a rubber float in a diagonal direction to thejoints, in order to fill them completely. The excess material should be wiped after a while, using a wet sponge. Finally, the surface maybe cleaned with a dry cloth. Outdoors or at high temperatures repeated dampening is recommended after a few hoursand when the grout has dried.CONSUMPTION0.2-2.0 kg/m², depending on tile size and joint width.